220V Round-Plug Heat G-un - DIY Crafting Tool for Rubber Stamps, Embossing Powder, Shrink Plastic, and Polymer Clay

Product Description:
Material: Steel, Plastic
Operating Temperature: 200°C
Rated Power: 300W
Rated Voltage: 110V (50-60Hz)
Plug Type: EU Standard Plug (220V)
Color: Blue

Product Features:
1. Suitable for heating embossing powder and heat-shrink sheets.
2. When in use, please maintain a distance of 3–5 cm between the heat g-un and the workpiece, and apply heat at an angle of approximately 45 degrees until the process is complete.
3. Once heating is finished, please continue to use the heat g-un to blow hot air over the workpiece for several minutes.
4. This procedure not only increases the hardness of the workpiece but also enhances its surface gloss.
5. The temperature is non-adjustable; theoretically, it can reach 200°C within a few seconds.
6. Do not operate continuously for more than 10 minutes; maintain a 45-degree angle while blowing to prevent heat backflow (suction).
7. Please exercise extreme caution when using this product.

Package Contents:
1 x Heat G-un

Safety Precautions:
For your safety, never touch the high-temperature nozzle or any melted material.
Please keep this product out of the reach of children.