2T S-cissor Jack, Car jack, Suitable for automotive repair

2-Ton S-cissor Jack with Crank Handle – Suitable for automotive repairs
User Manual:
Before lifting, park the vehicle on a firm, level surface, firmly engage the parking brake to prevent wheel movement, and turn on the hazard lights.
Chock the wheel diagonally opposite the tire being replaced; loosen the lug nuts on the wheel in question without removing them completely.
Remove the jack and use the crank handle or a wrench to adjust it to the appropriate height.
Position the jack under the vehicle manufacturer's designated lifting point; turn the crank handle clockwise until the jack head makes contact with the lifting point, then ensure the contact is stable and secure.
Continue turning the crank handle to raise the vehicle to the required height, replace the tire, and then tighten the lug nuts.
Important Notes:
Never exceed the maximum rated load!
To ensure proper jack operation, keep the worm screw clean and well-lubricated. Apply a sufficient amount of oil to the screw before each use!
This product is designed exclusively for lifting and must never be used as a permanent support. It is strictly forbidden to go underneath the vehicle while it is supported by the jack!
Stop using the jack immediately if it tilts or becomes misaligned during lifting; correct its position before resuming the operation.
Package Contents:
2-Ton Jack x 1