915 Generation WiFi Module Wireless to Wired Bridge/2.4GHz Signal Repeater Router RJ45 Adapter Engineering DIY Network Devices VM300-H

1. Is an Industrial 2.4GHz WiFi Module/Router/Bridge/Signal Repeater, can achieve WiFi to Wired or Wired to WiFi function(WiFi to Ethernet or Ethernet to WiFi convert). Good Partner for Monitoring, DVR, IP camera, Medical-devices, IoT devices, Video transmission, Industrial PLC, PS3, Network Printer, Robot, Doll Machine, Fish Finder and more DIY Network Devices and Applications.
2. There are two hardware versions: Internal PCBA Antenna(VM300-L) and external antenna (VM300-H). Two external antenna RF female sockets (only VM300-H). Comes with a button to restore factory parameters. Wide power supply working voltage: DC5V--15V, please use an independent typical 5V/2A power adapter or brand mobile phone's 5V/2A power adapter to power. Support power input over-voltage protection function (automatic power-off when the power supply voltage exceeds 15.5V)
3. Main chip: MT7620N, 580MHz. 32Mb SDRAM, can be expanded to 64Mb; 4Mb SPI Flash, can be expanded to 16Mb (Byte). WiFi working frequency band: 2.4GHz, 2T2R dual antenna, 300Mbps transmission rate. Support 1--14 WiFi channels. Rated average power consumption Less than 2W. Module RF output power 14.5dBm/16dBm (two gear output power optional). Support temperature compensation and frequency stabilization technology (TAFC) to ensure the stability of WiFi signal. Support 802.11b/g/n mode
4. Working environment temperature: -20℃-- 50℃. There is no need to worry too much about the temperature of the casing, after a lot of testing, the device can work normally.
5. Two software-controllable working modes: Router mode, Bridge + Repeater mode. Support smart transparent Bridge mode, and support AP Client and AP Station at the same time. Support VDNS technology, domain name can be used to log in to the configuration page in bridge mode. The relevant parameters of the device can be configured through the WEB page configuration or the VCC mobile phone APP. The software can adjust two levels of WiFi RF output power (14.5dbm/16dbm)

Function Features:
1. Support SSA 1.2 version signal strength remote center alarm protocol
2. Support VONETS-Configuration Management Protocol V2.3 (confidential)
3. Support transparent transmission of serial and network data (VONETS-UART_UDP or TCP data forwarding instructions 3.0)
4. Online software upgrade.
Interface:
1 DC2.0 power hole; 1 dedicated two in one power supply cable, with a set of power supply and a set of 10/100M adaptive Ethernet cable;
LED Status instruction:
WiFi state/Hotspot connection state (Blue light);
Ethernet port state (light Green for success);
Reset Button: Long press 5 seconds then release (During operation, the product can not be powered down, otherwise it may cause damage to the product.)
Tips:
1. After configuration, if this device doesn't work with your devices or your application is AC managed AP, for GoPro camera, for Cisco AP, for Hikvision surveillance system, please change the setting of "Transmission mode" to "MAC layer transparent";
2. If you want to use for Huawei or iPhone as the source hotspot for WiFi Bridge, when you setting, please select "SSID and password match" in the "Advanced Setting" under the upper-level hotspot password during configuration.
Colour:As Shown
Material:PC+Metal

Package Contents:
1 * VM300-H WiFi Module
2 * 2.4G External Antennas

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.