6-60v 30A 10A Lead-acid Solar Battery Charge Controller Protection Board charger Time switch 12v 24v 36v 48v battery capacity

Module Highlights:
Support Lead-acid battery and Acting Battery,voltage range:6V~60V;
Can display voltage,percent of battery,charging time at the same time through LCD;
The function is very powerful,realizes the automatic charge control, the control charge time, also may set up and uploads the corresponding parameter through the serial port;
Function description:
1. Automatic Charge control function:
By setting the volt-HI:''UP'' volt-LI:''dn'';When the battery voltage is below the volt-LI:''dn'',the relay leads,the charger begins to charge the battery;when the battery voltage is up to volt-HI:''UP'',the relay is diconnected and the automatic charge is completed once;
2. Charge Time Control Function:
How to turn on the time control function?
After entering the parameter set, set the parameter op is non-zero, then turn on the time control function, op default parameter is:--:--h, the default does not turn on time control function;
After the opening Time control function (OP is non-zero), when the battery voltage is the lower volt-LI''dn'', the charger began to charge the battery, the system began to clock; During the timing, the battery voltage ≥ volt-HI''UP'', relay disconnect; If the OP time is up, the battery voltage is still the lower volt-LI''dn'', the relay keeps the conduction, automatically closes the charge time control function, and flashes the H:ER to remind the user, the time parameter setting is unreasonable; Press any key to stop flashing;
Note: Time format: 00:59 (00 for hours, 59 for minutes) The maximum time is 99:59, which is 100 hours.
Parameter Setting:
Press and hold the SET key to enter the setting interface;
Switch the parameters you want to set by short press SET;
After the selection of parameters, can be set by the UP/DOWN key to support the short press, long press (fast increase or decrease); To set other parameters, repeat step b, c);
After all parameters are set, long press set key to exit and save;
The Key Function Description:
In the Run interface (main interface):
Short press SET button to display the current set of parameters; Short press UP button, toggle display charge percentage and charging time;
Short Press DOWN button, select Turn on/off relay enabling, if the relay can be closed, will show '' off '' as a reminder;
Long press UP button, switch low power state
on:No operation in 10 minutes turn off backlight
OFF: Backlight is always bright
Long press SET button,enter the parameter settings.6-60v 30A 10A Lead-acid Solar Battery Charge Controller Protection Board charger Time switch 12v 24v 36v 48v battery capacity

1x packages