Adjustable Step Up Step Down Module Cc Cv Power Supply Module Dc Dc Solar Charger Charging Controller 4.8 To 30v

DC DC Automatic Solar energy Constant current charging generation voltage stabilization 60W High efficiency can boost step-down


Used for solar charging!


When the output is protected and disconnected, the input can be started when the voltage reaches the voltage again. It does not need to be disconnected and reconnected.






Introduction:



Wide voltage input 4.8-30V, wide voltage output 0.5-30V, both boost and buck, for example, you adjust the output voltage to 18V, then the input voltage will change between 5-30V, it will output 18V constant; Input 12V, adjust the potentiometer to set any output of 0.5-30V.



High power, high efficiency and better performance than the XL6009/LM2577 solution. Large external power high-voltage MOS, large package high current and high withstand voltage Schottky diode. Increase heat dissation and copper.



The current can be set to limit the output current, constant current drive, battery charging and other occasions.



It comes with an output anti-backflow function, so you don't need to add an anti-backflow diode when charging the battery.




Product parameters:



Input voltage: 4.8-30V



Output voltage: 0.5-30V



Output current:
 to long-term stability in the 3A, to strengthen the heat can reach 4A



Output power: 
natural cooling 35W, strengthen the heat 60W



Conversion efficiency: 88% or so



Short circuit protection: Yes



Operating frequency: 180KHZ



Size: Length * Width * Height 68 * 37 * 22mm



Weight: 40g



Module use:



1. Used as a general step-up and step-down module with overcurrent protection capability



Instructions:



(1) Adjust the CV constant voltage potentiometer so that the output voltage reaches the value you want.



(2) with the multimeter 10A current measurement output short-circuit current (directly to the two test leads can be connected to the output), while adjusting the CC constant current potentiometer so that the output current to achieve a predetermined over-current protection value. (Such as multimeter shows the current value is 2A, then you use the module when the maximum current can only be 2A, the current to 2A when the red constant voltage constant current indicator light, otherwise the indicator light off)



Note: When used in this state, because the output has 0.05 current sampling resistor, connected to the load will be 0 ~ 0.3V voltage drop, this is a normal phenomenon! This voltage drop is not pulled down by your load, but is reduced to the sampling resistor.



2. Used as a battery charger



Non-constant current function of the module can not be used to charge the battery, due to the power consumption of the battery and the charger is very large, resulting in charging current is too large, resulting in battery damage, so the beginning of the battery to use constant Flow charge, when the charge to a certain extent, when the automatic switching back to constant voltage charging.



Instructions:



(1) to determine the you need to recharge the battery voltage and charge current, if the lithium battery parameters of 3.7V / 2200mAh, then the float voltage of 4.2V, the maximum charge current of 1C, or 2200mA.



(2) no-load conditions, the multimeter to measure the output voltage, adjust the constant voltage potentiometer so that the output voltage to float voltage; (if the 3.7V lithium battery charge, the output voltage can be adjusted to 4.2V)



(3) with a multimeter 10A current measurement output short-circuit current (directly to the two test leads can be connected to the output), while adjusting the constant current potentiometer so that the output current reaches a predetermined charge current value;



(4) Charging Turn the lamp current factory default 0.1 times the charging current. (The battery in the process of charging the current is gradually reduced, and gradually from constant current charging to constant voltage charging, if the charge current is set to 1A, then when the charge current is less than 0.1A, the blue light off, green light Since the battery charge is completed)



(5) connected to the battery, charging.



(Steps 1, 2, 3, 4 are: input termination power supply, the output does not load the battery)



3. Used as a high power LED constant current drive module



(1) determine the operating current and maximum operating voltage you need to drive the LED;



(2) under no-load conditions, multimeter to measure the output voltage, adjust the constant voltage potentiometer to the output voltage to LED maximum operating voltage;



(3) measuring the output short-circuit current with the multimeter 10A current level while adjusting the constant current potentiometer so that the output current reaches the predetermined LED operating current;



(4) connected to the LED, test machine.



(Step 1, 2, 3: input power supply, tAbout shping
Shping and Packaging All it will be double checked and well packed before sending.It will be dispatched within 2 business days after buyers pay for the order. It usually takes about 14 to 18 working days for delivering the package to the destination(for e areas,it may take a little longer). 

Special Announcement:
Please fill in the correct and detailed consignee, address and phone number in the order. For fast and correct delivery.If you do not receive order within 30 working days,please feel free to contact Customer Service before leaving Negative and Neutral Feedback, we will do our best to help you resoe the problem.TaxNo, you will only pay what is quoted as total cost at checkout, no more. You are not expected to pay any additional duties or taxes. If you are asked by Customs or our logistic partner to pay duties, please contact our Customer Service .

Your 100% satisfaction is very ant to us
If the product is not on good condition, You can return this product within 14 working days, please contact customer service center before returning.FeedbackYour satisfaction is our first priorityIf you receive the order and it is in good condition,we would be grateful if you would leave us 5 star Positive Feedback for the transaction.