Applicable to Huawei Mate30pro Tempered Film UV Full-Cover Screen Protector Mate20pro Anti-Peep Tempered Glass Film Anti-Blue Light

Liquid Glue UV Curing Tempered Glass Protector
Film Sticking Steps:
The Glue Falls down and Starts to Calculate. It Takes 1 Minute to Finish the Film and Turn on the Light. It Takes a Long Time. On the One Hand, the Glue Will Freeze When It Sees the Ultraviolet Light from the Sun. on the Other Hand, the Glue Runs to the Lower of the Two Sides, the Edge Glue Is Thin, and White Edges Are Easy to Appear. This Is the Cause.
1 Wipe the Phone with Film Cleansing Kit until It Is Clean and Satisfactory.
2 Stick to the Earpiece Hole with Dust Sticker. Stick Dust Sticker Holes with Button.
3 Drop the Customized Glue on the Glass Screen That Is Flat and Clean. Each Glue Should Be Used at the Discretion. It Is Recommended That the Glue Be Poured out and the Excess Glue Should Be Wiped Clean before Turning on the Light.
4 Align One End of the Film with the Screen, Make the Glass Touch the Glue, and Slowly Put down the Glass on the Other End (If There Are Bubbles in the Process, Lift and Replay until There Are No Bubbles)
5 Wait for about 30 Seconds to Let the Glue Slowly Spread and Flatten.
6 There Is Glue Overflow, Wipe It off with Dust-Free Cloth. After Checking the Retention Standard of Tempered Glass Screen Protector for Mobile Phone, the Light Shines Back and Forth around the Edge of the Mobile Phone Three Times, (Not in the Middle) and Then Wipe off the Edge Glue after Initial Curing for 3 Seconds until the Overflow Glue Does Not Exist. (Prevent White Edges Or Long Bubbles)
7 Wait until the Exhaust Is Finished, after the Glue Overflow Is Cleaned, after the Positioning Standard of the Tempered Film, Turn on the Light after Being Satisfied. Otherwise, Scrap the Material.
8 to Irradiate the Mobile Phone under UV Light, It Needs to Be Ironed up and down Twice for about 60 Seconds to Reach the Fully Cured Position.
9 Film Completed!
Film Precautions
1 Slow Exhaust and Normal Glue Overflow.
2 The Exhaust Is Not Finished in the Small Corner, Which Can Be Repair Cementing. It Is Recommended to Raise the Other Side Or Run the Glue.
3 Indoor Stickers Do Not Expose to the Sun.
4 after the Light Is Turned on, the Tempered Film Will Be Scrapped.
5 before Turning on the Light, Handle the Spilled Glue First.
6 First Examination Light Whether It Is on.