Applicable to New Qianrima Threshold Bar Highlight Strip Qianrima SST Bumper Welcome Pedal Scratch Resistant Patch

Installation Instructions
1. Simulation InstallationAdjust the Position of the Product to Be Installed on the Car to the Exact Position.2. Surface Treatment(1) CleaningUse a Towel to Touch Alcohol Or Clean the Car Body with Clean Water on the Parts to Be Installed.(2) PrecautionsBefore Installation, Keep the Car Body Dry and Free of Dust, Oil and Wax. the Temperature below 10 Degrees Must Warm the Double-Sided Adhesive Tape on the Car Body and Products.
(3) Use of Tackifier
Wipe the Position (Body) of Sticky with Cotton Swabs Or Paper Towels (a Small Amount) at the Position to Be Sticky.
(4) Installation
Tear off One Corner of the Double-Sided Adhesive Protective Film on the Back of the Product First, Leave the Film outside to Make the Product Coincide with the Installation Position, and Then Slowly Tear off the Film and Press It.
(5) Period
No Contact with Water, Oil, and Large Dust Within 48 Hours (Sticky) after the Product Is Installed.
Note: Please Compare before Installation. Tear off the Adhesive Red Film on the Back and Refuse to Return Or Exchange It.

There could be some deviations due to manual measurement or slight color difference owing to photographing condition. Thank you for your understanding. If you do not understand what you can contact customer service at any time, I wish you a happy shopping.