Mini Oscilloscope 0KHz Bandwidth 2.5MSa/s Sine Wave/Square Wave/Half Wave/Zinke Wave Entry-Level Oscilloscope

Mini Oscilloscope 0KHz Bandwidth 2.5MSa/s Sine Wave/Square Wave/Half Wave/Zinke Wave Entry-Level Oscilloscope

Specifications

Weight with packaging: 160gSampling rate: 2.5MHzAnalog bandwidth: 0KHz (sine wave)Actual bandwidth: 200KHzMeasuring voltage: X1/± 40V X10/± 400VInput impedance: 1M ΩStorage depth: 1Kb display: 12 typesPWM output: frequency 1k~80KHz duty cycle 0~100% output voltage 3.3VFunction waveform: 17 waveformsOutput: Frequency 1-1KHz Voltage range Vpp 0-3.3V (non adjustable)Display: 2.4 inch TFT, 320 * 240 resolutionCharging voltage: 5VBattery capacity: 600mA/h 3.7VUpper computer: temporarily not supportedFirmware upgrade: supportedSize: mm wide and 100mm long (excluding BNC head)Package List:Mini oscilloscope * 1Crocodile clamp measurement * 1High preure probe * 1 (available in high-end versions)

Features

1. Use high-quty materials for durabilitySample rate of 2.2.5MHz, actual bandwidth of 200KHz, analog bandwidth of 0KHz (sine wave)3. With complete triggering function (single, normal, automatic), it can be used freely for both periodic analog signals and non periodic digital signals4. The highest measurable voltage signal is ± 400V5. Equipped with efficient one click AUTO, it can display the measured waveform without complicated adjustments6. With one click waveform saving function

Precautions

When measuring a voltage exceeding 40V, be sure to shift the probe to X10When measuring high voltage (exceeding 36V AC voltage), do not touch the metal parts of the instrument, especially the BNC interface position3. The charging voltage should not exceed 6.8V to avoid ing out the charging chipWhen not upgrading the firmware, try to turn the switch in the bottom left corner to the Normal position as much as poible

Partial description:

1.2uS and 5uS cannot be used to measure waveforms other than sine waves.2. Saving the waveform can only save the current displayed part.3.Some of the measured signals cannot be captured correctly using AUTO and require manual adjustment.4. Firmware upgrade: To upgrade the display section, pre OK to start up, and to upgrade the bottom section, pre SAVE to start up.