NRF24L01 Wireless Module 2.4G Wireless Communication Module 24L01 upgraded version send a full set of information

NRF24L01 is a monolithic transceiver chip working in the 2.4-2.5GHz world general ISM band, the wireless transceiver includes: Frequency Generator Enhanced SchockBurstTM Mode Controller Power Amplifier Crystal Amplifier Modulator Demodulator Output Power Channel Selection and Protocol Setting can be set up through the SPI interface Extremely Low Current Consumption when working in the Extremely low current consumption, 9.0mA at 6dBm transmit power in transmit mode, 12.3mA in receive mode, and even lower in power-down and standby modes.
Ball Open ISM band with 0dBm maximum transmit power for license free use. Open 100 meters!

Support six channels of data reception
1. Low operating voltage: 1.9~3.6V low voltage work
2. High speed: 2Mbps, due to the short transmission time in the air, it greatly reduces the collision phenomenon in the wireless transmission (the software sets the air transmission rate of 1Mbps or 2Mbps).
3. Multi-frequency: 125 frequency points to meet the needs of multi-point communication and frequency hopping communication.
4. Ultra-compact: Built-in 2.4GHz antenna, compact size, 15x29mm (including antenna).
5. Low Power Consumption: When working in answer mode communication, the fast air transmission and start-up time greatly reduces the current consumption.
6. Low application cost: NRF24L01 integrated with all the RF protocol-related high-speed signal processing part, such as: automatic retransmission of lost packets and automatic generation of answer signals, etc., NRF24L01 SPI interface can be used to connect to the microcontroller's hardware SPI port or simulated with the microcontroller I / 0 port, internal FIF0 can be interfaced with a variety of high and low-speed microprocessor interface to facilitate the use of low-cost microcontroller. use of low-cost microcontrollers.
7. Easy to develop: Since the link layer is fully integrated in the module, it is very easy to develop. Automatic retransmission function, automatic detection and retransmission of lost packets, retransmission time and the number of retransmissions can be controlled by software Automatic storage of packets that do not receive an answer signal Automatic answer function after receiving valid data, the module automatically sends an answer signal, no need to be programmed separately Carrier Detection - Fixed Frequency Detection Built-in hardware CRC error checking and point-to-multipoint communication address control Packet Transmission Error Counter and Carrier Detection Functions Can be used for frequency hopping settings can be set simultaneously six receiving channel address, can selectively open the receiving channel standard pin Dip2.54MM spacing interface, easy to embedded applications