Push start e start by e controller fit for Toyota H Hyundai KIA FORD MAZDA VW Cheolet Mitsubishi

Push start and e start by e controller

1.Product ConfigurationMain control box : 1 pcsOne key start on : 1pcsEngine Start Wire : 1pcsControl Wire : 1pcs2. FeaturesThe system can learn the car e control lock/unlofunction as arm/disarm,When disarmed by e control, the car can be started by the engine ON/OFF on,when armed, the car can’t be started .e engine start function by e controller.3. Function introduction3.1 the car e control, to active the system arm/disarmIt need connect lo/unlopositive signal wire and direction lamp wire for arm/disarm by e controller3.2 ArmAr loon preed , the LED light in the push on will f once , the system will arm , the engine can’t start.3.3 DisarmAr unloon preed , the LED light in the push on will f twice, the system will disarm , the engine can start3.4 Engine one-key StartOne key start: Step on the foot brake, pre the on,the engine will be started。3.5 Engine offStep on the foot brake, pre the key again ,the engine will be off。3.6 Turn on ACC, ONDon’t step on the foot brake, Pre the key one time, ACC is turned on, pre the key again ,ON is turned on,and if pre the key again, ACC ,ON will be turned off3.7 Cenl locking automaticallyStep the foot brake ar driving cars for 15 seconds, the cenl locking system will lothe car doors; when stop the car, the cenl locking system will unlothe car doors.（Note :Need to connect the control wires of cenl locking, if the car has this function, do not connect the wires)3.8 Automatic arm ar engine offAr engine off , if the r don’t arm in 120 seconds , the system will arm automatically.(Note: This feature is disabled by default, to enable or disable it by this step: step on the foot brake ,then to do e start , then release the foot brake ar engine started, repeat this step to disable /enable this function)3.9 e startPre the unloon of the e controller 5 times in 5 seconds, the engine will be started.Note : it can also be set to pre loon of e controller to e start .refer to the installation diagram4. Jumper setting：The system can be adapted to different vehicles by setting jumper on the :1.S4, Open : e start by loon of e controller , Short : e start by unloon of e controller .Default is Short2.S3,Open: Suitable for the vehicle that the power of foot brake supplied by ACC or ON ,like as VW ,FORD , if short it , these vehicles need to be started by pre the key twice or three times , Short : Suitable for the vehicle that the power of foot brake supplied by the vehicle battery directly . Default is Short.3.S2 :Open : engine start time is 1.2 second . Short : engine start time is 0.8 second .