Stevenson Metalrite Coast Prime MR 200 1L - Black

Metalrite Coast Prime MR 200 is an anti-corrosive acid etch primer for all clean galvanized iron and non-ferrous metals. A Pre-treatment primer for new steel surfaces, clean galvanized steel, roof metal sheet and Chromadek. Contains Zinc Phosphate which provides excellent anti-corrosive properties. It may be over-coated with a wide range of topcoats such as alkyds, vinyl and water-based acrylic paints.  

Specification: 

• Type : Modified alkyd based with Zinc Phosphate pigment
•  Appearance: Matt finish
• Colors:  Black
•  Solids Approx.:  51% by mass; 39% by volume 
• SG at 23ᵒC : Approx.: 1.35 
• Theoretical spreading rate: ±8-10m²/ℓ depending on surface  porosity.

Cautions  

• Do not apply if rain is imminent
• . Apply at an ambient temperature of 10°C to 35°C. 
•  Ensure good ventilation.
•  Quick drying - avoid application to very hot surfaces. 
• Mixing -  Stir thoroughly with a flat paddle before use 
• Method - Brush, roller or spray 
• Thinning -  Not recommended - Ready for use 
•  Cleaning -  Enamel thinners 
•  Drying time  Touch dry - 30min (extend during cold, wet or humid conditions) 
• Recoating time 1 hour - not longer than 48 hours
•  Application  -Apply a minimum of two coats 

Surface Preparation  Ensure that the surface is properly dry and in sound condition, free from dust, grease, oil, algae, fungus or any loose particles before painting.   New Surfaces

•  Galvanised Iron, Aluminium and all non-ferrous metals: 
•   Clean and degrease with metalrite galvanized iron cleaner until a water break free surface is obtained.
•  Apply one or two coats Metalrite Coast Prime MR200 depending on the severity of the conditions
•  Ensure that surfaces are dry, sound, and free from dust, dirt, grease and oil before painting. 

 Mild steel:

•   Degrease with good degreaser.
•  Rinse thoroughly with water.
•  Remove any rust by coarse sanding, mechanical grinding or Metalrite remover
•  Rinse thoroughly with water and allow drying. 

 Previously painted surfaces

•  Thoroughly clean and prepare surface by removing all dirt, grease, grime and flaking/peeling paint before painting.
•  Treat as new surface. 

 
Safety Precautions

•    Keep out of reach of children.
•   Ensure good ventilation during application and drying.
•   In case of skin contact, wash with soap and water or a recognized skin cleanser.
•   Avoid contact with eyes — in case of contact, rinse eyes immediately with plenty of water and seek medical advice if symptoms persist.
•   Harmful if swallowed. Do not induce vomiting. Seek medical attention.
•  Refer to the Material Safety Data Sheet for complete information.